Page 1 of 1
Zone VI Compensating Developing Timer repair needed
Posted: Sat Feb 27, 2016 6:59 pm
by jwilliams3195
I've been using my ZVI CDT for 22 years. The "Real Time" and "Paper" work just fine. However, the "Film" is so off base that this component for film development is untrustworthy/unusable. Is there a reputable source for repair or, perhaps, chip replacement? If not, what are reasonable alternatives? BTW, I use a PROTEMP to keep within 67.8 - 68.2 C for film development. Thanks in advance, Justin
Zone VI Compensating Developing Timer repair needed
Posted: Mon Apr 25, 2016 8:23 am
by JB Harlin
Based on the fact that the Paper setting works fine, would eliminate a failure of the probe or possible bad connection of the probe connector. I would venture to guess that the rotary switch is not making a reliable connection in the Film position. Oxidation or wear??? You might try using a switch/relay contact cleaner on the switch. Open the unit, spray the cleaner into the rotary switch and then exercise it back and forth.
I have no idea where you can get service on these units now that Calumet is gone??? The unit we use is over 20 years old now and still functions fine. . . fingers crossed!!!
Zone VI Compensating Developing Timer repair needed
Posted: Mon Apr 25, 2016 8:22 pm
by darkroommike
jwilliams3195 wrote: I've been using my ZVI CDT for 22 years. The "Real Time" and "Paper" work just fine. However, the "Film" is so off base that this component for film development is untrustworthy/unusable. Is there a reputable source for repair or, perhaps, chip replacement? If not, what are reasonable alternatives? BTW, I use a PROTEMP to keep within 67.8 - 68.2 C for film development. Thanks in advance, Justin
I'm sure you meant degrees F. The only guy I know that might know someone is RT Ritter who was a designer for Zone VI, he doesn't work on electronics but you might ask where he would send his timer. Contact info:
Richard T Ritter
POB 401
Townshend, VT. 05353-0401
(802) 365-7807
8 AM to 6PM Week Days
&
Saturdays by chance
rrlg4mat@sover.net
Re: Zone VI Compensating Developing Timer repair needed
Posted: Mon Apr 29, 2024 11:47 am
by tundratim
I know this is probably a zombie thread at this point, but in case the OP or anyone else is still tuned in ...
In anticipation of my own Zone VI dev timer going bad (it hasn't yet!), I designed and built my own replacement - this should be well within the skills of an electronics hobbyist to build or perhaps a high school or college hacker:
https://gitbucket.tundraware.com/tundra/devtimer